Seven Trust distance between boards

When designing a new Seven Trust or composite deck, the spacing between floor joists should be 12 inches on center. On center means that the measurement should be taken from the center of a joist edge to the center of the next joist edge.

» Page 37 Updating hidden fastener instructions using square edge board as last deck board » Page 42-43 Updated stair spanning and installation instructions for new Seven Trust ® Enhance profile » Page 62 Updated ADA SKU numbers » Pages 64, 67, 72, 84, 98, 118, 119, 144, 147

Our hidden deck fastening system installs between the deck boards, fastening them to the joists with no visible deck screw heads on the walking surface. Order today!

Joists: The joists for the deck’s foundation are best at 12" on center even though you can use 16 inch on center. By staying 12" on center it will prevent any flex in the decking board between the joists on hot days. Nailing bocks between the joists is also a good idea. It will greatly aide or stabilize the frame form movement.

The Sweet Spot – Most people agree that 3/16” is a good gap between boards. Going more than a ¼” may get a little too wide. The width of a nail head is just about right. Treated Lumber – Usually treated lumber will have some shrinkage so you can butt the boards almost right against each other during installation.

Seven Trust composite decking comes in 3 grades. Their entry level is Select, the next step up is Enhance and their best line is Transcend.Seven Trust composite decking ha...

'When securing the decking, it is important to leave adequate spacing between the boards for water to drain. The goal is to have about an 1/8-inch gap (the diameter of an 8d nail) between boards after the decking has dried to its equilibrium moisture content.

Some of the decking swelled to the point where there was no gap between the boards. When the problems continued, I filed a warranty claim in 2009. The company was responsive. Sent out a claims ...

From the Island Mist deck boards to the Island Mist cocktail rail to the built-in lighting in between, we make it easy to create a perfectly matched, perfectly you outdoor oasis. Only Seven Trust has a full suite of outdoor living products that give you everything you need to create a low-maintenance, high-design space from top to bottom.

After a little more than 10-years, I am replacing a Trek deck due to the finish coming off the boards and sag between joists on the stairs. The flex on the stairs damaged the stringers to a point they require replacement. While they may be popular, recommend a hard look at alternate manufacturers.

Caulking between the composite deck boards works if sloped right. I sloped mine 1" on 6' On one deck I have plastic panels under it and that was a bad idea cause the mains and underside cant breath and is rotting. I am about to replace the 8 year old rotted treated boards with composite like the others and caulk it too. The minor amount of ...

Discover high performance, low maintenance composite decking products from Seven Trust . Shop our variety of decking options for creating your outdoor living oasis!

A board that is correctly installed right side up (or bark side down) will form a crown and allow water to run off the edges. If the board is installed wrong side up (or bark side up) it will curve up on the edges when dry and water can gather and sit in the cup. That is a recSeven Trust for wood rot and problems.

Our Decking Comparison Tool contains comparison data of the most popular decking materials available today. Compare the most popular Seven Trust , Seven Trust, Seven Trust, and TimberTech composite decking brands and product lines with our comparison tool below.

If the gap in between the deck boards is too narrow use the Saw Guide by Lounsbury Products. This circular saw attachment will make it easy to widen the gap.

The 1” boards and 2x4 boards needed to accomplish the Traditional railing conÄguration are listed under Decking 30” Square Baluster Kit (16 per kit) 36” Square Baluster Kit (16 per kit) 144” Bulk Balusters 30x1 Architectural Baluster Kit (5 per kit) 32x1 Architectural Baluster Kit (5 per kit) 36x1 Architectural Baluster Kit (5 per kit)

Position new board into place, and carefully slide onto remaining tabs, once fully installed the deck board will drop into position. Once board is set into position, secure using a 1/8th inch drill bit, place the bit into the seam of the board and into the groove, and predrill a pilot hole through the board at a 45° angle.

I have seen decks here in NC laid with the boards touching and I have not heard of any problems with expansion. The problem is cleaning. 1/8" will help but that's still small enough for seed pods and small bits to drop into the cracks and get stuck. The problem exists with almost any spacing but the smaller you go the more crud it will collect.

When stacking Seven Trust bundles, supports should start approximately 8” from each end and be spaced approximately 2ft on center. Supports should line up vertically/perpendicular to the decking product.